Vinyl Post Wrap Installation

AttachmentSize
PDF icon post wrap Instructions.pdf104.78 KB

Tools and Supplies Needed:

  • Measuring Tape
  • PVC Cement (optional)
  • Saw with fine tooth blade
  • Hammer and Roofing nails (optional)

Installation:

  1. Measure the length of post wrap needed and cut to length using a fine tooth saw. Then, place the first piece of post wrap against the post and fasten through the fastening flange.
  2. Insert the flat end of the second piece of post wrap into the assembly slot of the first piece. Again attach to the post using fasteners through the fastening flange.
  3. Repeat the previous step to fasten the third piece of post wrap.
  4. When attaching the last piece of post wrap, once again begin by inserting the flat end into the assembly slot of the previous piece. Next slide the slot of the fourth piece over the flat end of the first piece. PVC cement may be used where the flat ends insert into the assembly slot.
  5. Base trims are a universal size that can be trimmed to fit using a fine tooth saw. Measure the size of base trim needed and cut to length using a fine tooth saw. The under side of the base trim pieces are marked to aid in measuring. Assemble the base trim using the same method as the post wrap.